Embedding strategies and skills of video and speak

2022-07-22
  • Detail

With the continuous progress of technology, audiophiles' requirements for the effect of equipment are also constantly improving, and the continuous upgrading of equipment will also upgrade the requirements for wire rod. Therefore, video cable, audio cable, speaker cable and power cable also need to be tested more and more

when wiring, because the specific situation of each household is different, the wiring method should be determined according to the specific situation and local conditions. According to the acoustic law, the sound effect of the speakers, especially the front left front right surround speakers, placed on the side of the short wall is better than that of the long wall. Because the subwoofer has no obvious directionality, it can be placed anywhere on the ground of the same room. Generally, there is no need to bury the line, but if it is not placed on the wall in front of the listener, it is natural to choose a good position for embedding the line

usually we need to bury the cable, and generally only the rear surround speaker. In the 5.1 system, there is only one pair of surround, but as a long-term consideration, on this basis, it is best to set up one or two groups of rear surround speaker lines in case of upgrading to 7.1 or 8.1 channels in the future. When embedding wires, whether it is digging holes on the floor or chiseling grooves on the wall, it is recommended to use plastic casing or yellow wax pipe to cover the horn wire, do a good job of protection, and do not directly seal it with cement. If possible, it is better to use a sleeve for each speaker cable. Secondly, it is best to use plastic coil pipe (a kind of semi-rigid, translucent and commonly used in formal building construction) to make there is no joint in the middle of the pipe, so that the line will not get stuck when threading. If there must be a connector in the middle, it should also be inserted with a large and small head, and the direction should be consistent

sufficient length shall be reserved for the outgoing part of the buried wire. For the exposed part of the unused horn cable, the cable can be stored by installing a white board box. Whiteboard box is a box of the same size as the commonly used standard power socket (8cm × 215; 6cm box), which can hide a certain length of wire and cover the box board, and it is very beautiful. In the future, if the hidden thread is pulled out, the box does not need to be removed. In addition, this is also convenient for the maintenance of the speaker connector, because the connector will inevitably be eroded by the air after a long time of use, resulting in a layer of oxide on the surface. When there is a layer of oxide on both the male and female connectors, is the signal line that you spend a lot of money on still useful? Using a white board box, you can easily use something similar to clean aluminum 99 at any time, and polish the surface of the joint to ensure cleanliness

南京银屑病医院

厦门妇产医院

郑州甲状腺医院

合肥精神医院

Copyright © 2011 JIN SHI